CNET cn5614xr Specifications download pdf (Page 50)

External Paging

4-2 ◆ Section 4: Optional Equipment DS2000 Hardware Manual

External Paging Relay Control

An announcement broadcast into a Paging zone can additionally activate the system relay in the CPU PCB.

The following products should help if you make your own cables. The connector is generally referred to as a

RJ45 connector wired in an RJ61X conﬁguration. Check with your local supplier for comparable products.

● Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or SE-166-6 modular crimping tool).

● Hubbell BRFT4P Snap-On 8 Position Modular Plug (does not require a special crimping tool).

Connecting the Relay for External Paging Control

To Connect the CPU Relay for External Paging Control (Figure 4-2)

1. Find an available connector in a station cable and make sure it is correctly punched down at the

66M1-50 block.

Follow standard color code order. Be sure the block is properly cross-connected.

2. For the connector chosen, locate pins 3T and 3R and connect the device the relays will control.

3. Plug the modular jack into the CPU modular connector.

!! Important !!

Be sure the device connected to the system’s relay contacts is compatible with the following speciﬁcations.

Relay Contact Speciﬁcations

Contact Conﬁguration: Normally Open

Maximum Load: 60mA @ 30 VDC

10 mA @ 90 VDC

Maximum Initial Contact Resistance: 50 mOhms

Figure 4-2: Connecting the Control Relay for External Paging

RJ61X

Latch

faces up

To CPU

Mod Jack

Note

reversal

Port

Designation

To 66 Block

WHT-BLU (1T)

BLU-WHT (1R)

WHT-ORN (2T)

ORN-WHT (2R)

WHT-GRN (3T)

GRN-WHT (3R)

WHT-BRN (4T)

BRN-WHT (4R)

80000 - 18

Page Out

Music In

Relay Contacts

No Connection

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 85 86

Comments to this Manuals

No comments

CNET cn5614xr Specifications Page 50

Comments to this Manuals

Related products and manuals for Networking CNET cn5614xr