CNET cn5614xr Specifications download pdf (Page 14)

Installing the Cabinet

1-8 ◆ Section 1: Installing the Cabinet DS2000 Hardware Manual

Installing the Cabinet

Planning the Installation

Before installing the common equipment, you should mount a Main Distribution Frame (MDF) plywood back-

board in a centrally located spot. A 1/2 sheet of plywood (4’ x 4’) should be adequate for a 4 slot cabinet (see

Figure 1-1

4 Slot Cabinet Installation Layout

below). A full sheet of plywood (8’ x 4’) should be adequate for

an 8 slot cabinet (see Figure 1-2

8 Slot Cabinet Installation Layout on page 1-9

). Be sure to mount the back-

board using suitable fasteners, taking care to adhere to standard installation practices and local codes.

The equipment cabinet requires a three-prong, dedicated 110 VAC 60 Hz circuit (NEMA 5-15 receptacle).

The AC receptacle must be within 7 feet of the cabinet’s lower left corner.

Normally, you install the extension and trunk blocks to the right of the cabinet. Telco should also install the

RJ21X to the right of the cabinet.

!! Important !!

Local codes may prohibit you from installing extensions,

trunks and optional equipment in the same blocks.

Figure 1-1: 4 Slot Cabinet Installation Layout

80000 - 15A

Plywood backboard

Dedicated

AC Outlet

Surge

Protector

To earth

ground

To telco

ground

Station

Blocks

Station

Blocks

Trunk

Blocks

Note: The system will respond to telco ring signal in the

range of 40-130 VAC @ 20 Hz.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 85 86

No comments

CNET cn5614xr Specifications Page 14